Find Us
Postcode for your Sat Nav is DL1 4AQ. We’re located to the rear of Darlington railway station, see the Google map below.
Please note – Some navigation systems will take you to Matalan. Don’t panic, we’re just a hundred metres further along the road. Keep driving towards the town centre, we’re on the left!
Our business hours are:
Monday – Friday 8:30 til 5:30
Saturdays 8:30 til 1:00
Closed Sunday
Postal Address.
ExhaustaFix Ltd. Bank Top Garage, Neasham Road, Darlington, County Durham. DL1 4AQ
For a fast, competitive quote on your replacement exhaust, call us on 01325 362271. Our busy workshop and walk-in customers means that it sometimes can take more than 24 hours to respond to email requests.
- Please don’t email us with general enquiries about “can you fix this” or “how much would an XYZ exhaust cost?” Why not? Because the answer to the first question is nearly always “Yes, bring it down” and the second question is impossible to answer as there will always some little detail missing from the email.
- We run a busy workshop counter with lots of customers arriving, phones ringing etc and they take priority, so if your question needs a fast answer, call us on 01325 362271.
If that’s all ok, then fill out the form below with as much information as you can give and we’ll get back to you.
Excellent service and very proffesional staff, Excellent value for money and top quality workmanship,
Saved me a fortune repairing my exhaust instead of paying for dealer only parts for my ford mondeo st.
Highly recomend this garage to all and hope they open a branch in Sunderland.
They now have a customer who will be spreading the word and I will be a customer for as long as I own a car.
Cheers
Neil ( Sunderland )
I can recommend this company to all, but especially as a specialist needed for those of us who have older vehicles with little value but potentially expensive repair bills. They gave advice and resolved my problems at a fraction of the cost that I would have incurred had I followed the usual repairers route.
I have a 12 year old Audi A6 2.7T Quattro Avant and had a blowing flexi on one side. The genuine Audi parts for one side only of a new front system including the flexi, CAT, manifold etc are about £750 plus VAT plus fitting.
Exhaust-A-Fix cut out both flexis and welded new ones in at a very reasonable cost. They also pointed out a further developing fault on the system and advised that perhaps I should look out for a good second hand system – which I found through EBay (at Nirro Ltd, specialist VW/Audi breakers – 0208 594 7277 who I would also recomend) and which they fitted for me again at a reasonable cost. I now have a renovated system at a fraction of the cost that I would have paid through the normal route. There is always an alternative to fitting expensive new parts. I am grateful to Exhaust-A-Fix for the professionalism, technology, advice and service provided and am recommending them to all especially those who have older vehicles, which they cherish, as a good company to solve your exhaust problems.
David Peers
just wanted to say huge thanks to you for sorting exhaust on my ford focus. Kwik fit quoted £487, exhaust a fix £106. Amazing and manager so helpful . My car was sorted within the hour, he even dropped me at my dental appointment whilst they were attending to the repair. Would highly recommend
i have a custom mini with a bike engine in front , i was recomended this exhaust company by friends ,i rang them and asked for a custom made exhaust from down pipes with a centre box to a rear can mounted length ways at the back of the mini , i brought the mini on monday we discused what i wanted ,the whole exhaust was made in stainless steel and the car was ready to pick up on tuesday all done as agreed , i am very impressed with the work they did and would recomend this company to anyone
colin stallard
Excellent service, quick repair and very reasonably priced. Thank you. Made my day.
what a great service … happy chaps .. hard working … car in … job done … they saved me about £300 … if i had gone to a dealers .. so once once again lads .. thank you very much .. i would recommend you anytime.
Took our camper van here for a new front pipe because our local garage couldn’t find one so they told us to try these guys.They made us one and fitted it I less than 2 hours.Totally brilliant.Thanks guys.
[…] Find Us […]
Hi can you make and fit cat bk 2 my bmw 330d and how mutch is it thanks i would like it 2 look like a bmw 335d thanks
just taken my BMW 318 d se 2010 model in. all fixed for £120 and just driven back to North London. Car feels like brand new again. Cant recommend these guys enough. my main dealer quoted me a ludicrous £1750 to replace the whole piece and local tyre and exhaust centre quoted £550 for a patent replacement
So you can see what a big saving I made even by driving up there.
Just had an exhaust sort by these guys and they were tremendous . My back box was a real problem and going to be very expensive ( over £540 ) but these guys switched round the inlet pipe form another dealer part I got at hugely reduced price as obsolete and converted it to be a perfect fit so I’m all done back on the road for a third of the list price ..
Many many thanks guys and I will spread the word as a very happy customer.
I took my Saab 9-3 to be inspected as I have had a very noisy rumble since the rear box was replaced. The mechanic removed an aluminium sheet (heat shield?) whose fixings had worn out and was loose above the rear box, and we discussed other options. No charge made, and good advice given, but the real bonus was that the noise disappeared when I got back on the road. That sheet of metal must have been the cause. Thanks again guys. Brilliant.
Could not be happier with the service I got today. Had a repair done on my Octavia to get it through its MOT, quick and cheap but the job was beautifully done. Really nice people to deal with too. Many Thanks.
Hi how much for a pair of tx 012 tail pipes supply only
Hi, would you be able to make a full stainless exhaust inc front pipe for a Mk3 Escort fitted with a 1.8 Turbo Diesel engine? At the moment I am using a front pipe I constructed myself mated to an XR3i EFI exhaust but need a permanent solution. Appreciate I will need to bring the car in for you to finalise etc, just looking for an answer as to whether this is something you can do, rough cost and whether the car will need to be left with you or whether you can measure it up and I can come back for fitting later.
Needed both flexi’s doing on my Clio 197, Renault parts far to expensive.
These guys cut the old ones out and fit new ones, very happy with the price £250 (would have been 4 times that if had a new manifold cat replaced).
Guys are really friendly and don’t mess about (took 2hrs to complete then back down to Worcestershire).
I fully recommend these guys and would make the trip up north again when more work is needed.
Was recommended to Exhaust a fix after being quoted over £450 to replace a flexi hose and catalytic converter. They replaced the flexi hose and mid section for a fraction of the price and have since replaced the rear box, again for a reasonable price. Fast, reliable service and the guys are all extremely helpful and genuinely top blokes. Highly recommend this place to anyone. Thanks again.
Could you make bike pipes in stainless I have a Triumph Rocket 111 2.3lt. I have old ones for a pattern Single pipe in then Y and ballance to two boxes with slash cut.
Brilliant quick efficient service! I turned up with a broken exhaust at 8.30 and got my car back the same day at 12.30. Lovely, helpful chaps and a lift to work too! You can’t get much better customer service than that. Highly recommended. Cheers!
can you fabricate a motorbike exhaust system , i all ready have the end cans… it will be a 4 into 2 system so thats a right hand side and left hand side i need
thanks
Hi I have 2 Mercedes Sprinter silencers which I think you could use
Both appear to be unused with some surface pitting and in very good condition
I used to have a garage business in Darlington and have used your service previously
The retail price on the exhausts is £60 plus vat each giving a total of £144 but I would only ask £20 for both and can deliver
My email is Kevin.airey.is@googlemail.com and contact number is 07952 466925
Best wishes Kevin
I have a Lexus RX350, 2008 model. The exhaust pipe has snapped off from the silencer box, mid section. Is there anything you can do to fix it? Thanks – John Rhodes
Hi there! I have a Mercedes-Benz 500 SL (R129) The exhaust Broke away at the joint of the mid box to the back box, the back box is in good condition but needs a new bracket welding onto it? It may also need other parts?? Is there a Saturday but I can bring it along for you to look at?? Many thanks
Good morning,
Quote please, supply and fix from cat rearwards exhaust system for SEAT Ibiza Reg No NX 08. PVE.
Look forward to your reply.
Many thanks.
I’ve got a 2015 ford fiesta 1.0 ecoboost.on my m.o.t i was told that my flexi pipe was broken.any idea how much to replace please.
A retired K-6 teacher here and his bro our dream car F430 needs new/ used aftermarket headers the stock manifolds are defective! thx ! Jack and Neil Dale
PS. got the Capristo muffler already, came w/ the car !
Eventually i would like to have a system w/ exup style valves ! PS we are in USA
are you open part time at moment or completely closed thanks
My Ford Focus 2008 1.6 Zetec has a blow flexi pipe which is part of the cat converter. Is it possible to repair the flexi pipe?
I popped into your store a while back now for a quote. I received a quote for about £160 to replace the tips of my twin exhausts on my Nissan 350Z roadster & I was told it’d take about an hour. I am returning from another offshore task about the 3rd Sept & would like to book my car in to get the tips fitted, I am available any day/date on or about the 3rd. Would it be possible to book me in anytime please, pref an afternoon but can come in at short notice if you have someone not turn up for an appt. I am based in Middlesbrough. Many thanks
FAO Steve Fairley. Hi Steve, we met you and Sally last weekend at the Ballachulish Hotel and went out to dinner with you both at Laroche. I hope you had as good a time as us. This saved the whole wet and dreich weekend at the hotel. We did exchange contact details but for some reason I did not save Sally’s number correctly. Probably something to do with the wine. We would just like to thank you for your company which we thoroughly enjoyed. We awake early and left the hotel early and missed you unfortunately because we would like to thank you for your easy and enjoyable company and a great meal. Best wishes to you both.
Ian and Anne Duncan.
We have a rav4 2005 auto. Because the engine warning light comes on the AA man thought the sensor was being triggered by the catalytic converter, which he thought was a bit ratterly. Do we need a full exhaust system and how much would it cost. Many thanks…..Shirley Hardy.
Hello team, I am in the process of importing a 3.5 v6 E51 Nissan Elgrand and hope to have it on the road by the summer. Once I am up and running, I would like you to quote me for a full stainless steel exhaust system, including removing the front and rear pair of cats and replacing them with one pair of MOT compliant sports cats. My only other requests will be for the exhaust to release some of that lovely v6 sound, along with an inward rolled 4″ tip. I appreciate that you are physically closed at present, but please do feel free to contact me if thee is anything else you would like to know in the meantime.
Hi. I cant get car to you as its hours away and on a classic. but have you ever produced replacement exhaust systems by having old parts posted up and then copied? Obviously old parts are still usable so shape etc is correct.
Vehicle is singer gazelle 1965
Another system needed is on an audi 200 turbo. As before old bits can be posted to be copied.
Any help appreciated. Thanks
Hi I need a full exhaust pipe making for my 1986 Nissan laurel c32
Please email me on
maz78600@hotmail.com